How To Punch Down A Keystone Jack

A keystone jack is a small device used to connect network cables to the wall plate. It is designed to fit into a keystone-shaped hole, hence the name. Punching down a keystone jack may seem daunting, but it is a relatively simple process. In this article, we will guide you through the steps of punching down a keystone jack.

Tools Required

1. Keystone jack

2. Impact punch down tool

3. Cable stripper

4. Wire cutter

5. Network cable

Step 1: Preparing the Cable

Start by preparing the network cable that will be connected to the keystone jack. Cut the cable to the required length, and strip off approximately one inch of the outer jacket. This will expose the individual wires inside the cable.

Step 2: Organizing the Wires

Organize the wires in the order specified by the T568B standard. This is the most common wiring standard used for Ethernet networks. The wire colors should be arranged in the following order, from left to right:

1. Orange-White

2. Orange

3. Green-White

4. Blue

5. Blue-White

6. Green

7. Brown-White

8. Brown

Step 3: Inserting the Wires

Insert the wires into the appropriate slots on the keystone jack. Make sure that each wire goes into the correct slot. The keystone jack should have a diagram on it that shows which wire goes into each slot.

Step 4: Punching Down the Wires

Once the wires are inserted into the keystone jack, use the impact punch down tool to punch down each wire. This will secure the wire in place. Be careful not to damage the wires or the keystone jack when punching down the wires.

Step 5: Cutting the Excess Wire

After punching down all the wires, use the wire cutter to trim the excess wire. Make sure to leave enough wire so that it can be used to connect the keystone jack to the wall plate.

Step 6: Testing the Connection

Test the connection by connecting a network cable to the keystone jack and plugging it into a device such as a computer. Verify that the network is functioning correctly.

In conclusion, punching down a keystone jack is a straightforward process that requires minimal tools and expertise. With the right tools and proper instructions, you can successfully punch down a keystone jack and connect your network cables to the wall plate. Remember to follow the steps carefully to ensure that the connection is secure and functional.

If you want to know more about industrial network cabinet,china fiber optic splice closure,china fiber optic distribution box,please consult the fiber optic splice closure factory