How To Wire Cat6 Keystone Jack

A keystone jack is a female connector that is used to terminate and connect sections of Cat6 network cable. Cat6 keystone jacks are designed to meet the higher bandwidth requirements of modern networks and provide better performance than lower-grade jacks.

Wiring a Cat6 keystone jack is a relatively simple process and can be accomplished with minimal effort. Here is a step-by-step guide on how to wire a Cat6 keystone jack.

Step 1: Strip the cable jacket

Using a wire stripper, remove 1.5 inches (3.8 cm) of cable jacket from the end of the Cat6 cable, revealing the twisted pairs of wires inside.

Step 2: Untwist the pairs

Once the jacket has been removed, untwist the pairs of wires and separate them from each other. Be sure to keep them in their original color order, as this affects the accuracy of the signal.

Step 3: Straighten the wires

Using a pair of pliers or wire strippers, straighten the wires. Be careful not to damage or break the wires while straightening them.

Step 4: Insert the wires into the jack

Insert the wires into the corresponding color-coded slots in the jack. Use a punch-down tool to firmly seat the wires into the slots.

Step 5: Trim the excess wires

Once all the wires are seated, trim away any excess wire that is protruding from the jack. Be sure to leave enough wire to make a solid connection to the RJ45 connector.

Step 6: Test the connection

Insert the keystone jack into the corresponding socket on the wall plate or faceplate. Use a cable tester to ensure that the cable is wired correctly and that the connection is solid.

In conclusion, wiring a Cat6 keystone jack is a relatively simple process that requires minimal tools and no special skills. By following these steps and taking care to ensure that the wires are seated properly and in the correct color order, you can easily connect and terminate Cat6 network cable for optimal performance.

If you want to know more about industrial network cabinet,china fiber optic splice closure,china fiber optic distribution box,please consult the fiber optic splice closure factory