How To Make A Patch Cable Rj45

A patch cable, also known as an Ethernet cable or network cable, is used to connect two devices together for data transfer. This article will provide you with step-by-step instructions on how to make a patch cable with an RJ45 connector.

What you will need:

- Ethernet cable (CAT5e or CAT6)

- RJ45 connectors

- Crimping tool

- Wire cutter/stripper

Step 1: Strip the cable

Using a wire cutter/stripper, strip about 1 inch of the outer insulation off the end of the cable to expose the eight internal wires.

Step 2: Untwist the pairs

Gently untwist each of the four pairs of wires, making sure to keep them separated and organized.

Step 3: Align the wires

Using the T568B wiring standard, align the wires according to the following color order from left to right:

Orange/White - Orange - Green/White - Blue - Blue/White - Green - Brown/White - Brown

Make sure that the wires are pushed all the way to the end of the connector so that they make contact with the pins inside.

Step 4: Crimp the connector

Insert the connector into the crimping tool and squeeze it firmly to crimp the connector onto the cable. Make sure that the connector is securely attached to the cable and that the wires are not bent or misaligned.

Step 5: Repeat for the other end

Repeat steps 1-4 for the other end of the cable.

Step 6: Test the cable

Use a cable tester to test the cable for continuity and check that all the wires are connected properly. If the cable fails the test, double-check the wiring and try again.

Conclusion:

By following these six simple steps, you can make your own patch cable with an RJ45 connector. This is a cost-effective solution if you need a specific length of cable or just want to have the satisfaction of making your own.

If you want to know more about industrial network cabinet,china fiber optic splice closure,china fiber optic distribution box,please consult the fiber optic splice closure factory